The content of this topic has been archived on 12 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Hello Community,
I'M having 2 DWL 2000AP+ and 3 Linksys WRT54GL. the Linksys ones are running OpenWRT. I was wondering if it would be possible to bring these 2 old APs on OpenWRT, maybe only a Port of it.
Hardware Revision A1:
- MSP2007-CA-A2
- WLAN-Modul - TNETW1130GVF
Hardware Revision B2:
- TNETW5306PYP
- WLAN Modul - TNETW1130GVF
Thanks in Advance
(Last edited by underflyer on 12 May 2008, 09:14)
Hi
I have 2 DWL-2000AP+ too. I opened one of both.
I would solder a new (bigger) flash chip. Is it possible?
I already read from several procedures.
Do pin-compatible flash chips exist?
It would make me happy, if someone could help me. 
H/W Ver. B2
WL AP 2454 XT1 B10 VER:V1.2 (on PCB)
CPU TNETW5306PYP
RAM IC42S16400-7T (8MB, SDRAM, 3.3V)
Flash MX 29LV800BBTC-70 (1MB, Flash memory,8Mbit (1M×8-Bit/512K×16-Bit),3.0V,70/90/120(ns) Initial Access Times,48-pin TSOP)
WiFi Texas Instruments TNETW1130GVF (Mini-PCI, 2 antennas. One externally and one internally)
LAN Altima AC101LKQT (10/100BASE-TX SINGLE-PHY TRANSCEIVER)
PLD Altera EPM3032ATC44-10 (MAX 3000A Device Family (3.3V))
(Last edited by DWL2000 on 1 Mar 2009, 20:05)
The discussion might have continued from here.