I was experiencing bad serial terminal return key function.
The return key don't work... only write a strange chars in the same position over and over.
The other keys that i type just write te correct char and act ok.
This problem happens in lasts trunks, all old trunks works fine. Also i try the last trunk, and the problems persists. I tested vt100, linux, etc... with same results.
Any idea ?
Topic: trunk r28313 - serial terminal return key problems
The content of this topic has been archived on 12 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
fixed in trunk 28351 
The discussion might have continued from here.
Page 1 of 1