When booting failsafe mode on the ASUS WL-500G, only the WAN port alows telnet in. This is rather backwards.
The attached patch corrects the settings.
The content of this topic has been archived on 14 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
When booting failsafe mode on the ASUS WL-500G, only the WAN port alows telnet in. This is rather backwards.
The attached patch corrects the settings.
It seems .patch is not allowed.
The point of failsafe is only to get you in, it's not intended that you actually run in failsafe other than recovery.
The discussion might have continued from here.