Hello,

Please help me debrick a Trendnet TEW-632BRP router (which now runs official firmware, but I would like to install OpenWRT on it).

Exact hardware is Trendnet TEW-632BRP ver. A1.1R, last running 1.00b0042 or later.

Now I am unable to access the router (not mine, but no obvious or suspected hardware damage...), even after pressing the RESET button.

After powering on the unit, all LEDs light up continuously, except WLAN. There is no Ethernet connectivity.

Pressing RESET button for 15 s changes nothing.

By disconnecting power, pressing RESET, reapplying power, holding the RESET button for more than 30 s, then releasing, the router enters (probably) in failsafe mode: STATUS LED blinks, WLAN is off, all other LEDs are on. From my laptop, I still cannot establish Ethernet connectivity on any router's documented IP address (192.168.10.1, 192.168.0.1 or 192.168.1.1)

Please provide a way to restore default settings & connectivity.

Best regards,
Răzvan