The content of this topic has been archived on 3 May 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Hi,
I have a TP Link Router there have been used as withbox, but now i will use it as a router, I have try to active SSH on the box but it have not been succede for me.
Firmware in the box is
OS: OpenWrt Bleeding Edge r26878
SW: WR741ND Build
I have try all the guides i could find on the net, but without succes, port 23 is still only active.
Any one there could help.
Hi,
I have a TP Link Router there have been used as withbox, but now i will use it as a router, I have try to active SSH on the box but it have not been succede for me.
Firmware in the box is
OS: OpenWrt Bleeding Edge r26878
SW: WR741ND BuildI have try all the guides i could find on the net, but without succes, port 23 is still only active.
Any one there could help.
Did you set up password? For me is working:
1) telnet to device,
2) passwd (set new password)
After this, dropbear switch instance from telnet to ssh
Hi,
Yes, i have also tried to reboot the router, and its still on port 23
Hi,
Yes, i have also tried to reboot the router, and its still on port 23
This way works without reboot. There is in process list to see then generating ssh keys... Maybe other problem in your scenario...
Maybe, can it be done other ways
I have Solved the problem now :-)
Maybe you could share your solution?
I have a presumption i have forgot some command lines, i'm not sure
The discussion might have continued from here.