Hi all,
After following the docs for nvram settings, I've been trying to get a sane TX power. I set the following:
wl0_country_code=US
wl0_txpwr=19
but after boot, it still shows 7dBm in iwconfig. Any suggestions?
Thanks,
Jon
Topic: wl0_txpwr doesn't stick...boots to TX-Power: 7dBm
The content of this topic has been archived on 27 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
I don't think twpwr in mW equal dBm !
Read FAQ, twpwr doesn't really boost perfomance, because there will be more "noise" ....
Since RC6 you have to set wl0_txpwr in qdBm (1/4 dBm), so if you want so achieve 20 dBm, you have to set wl0_txpwr to 80.
@PraysToPan
whatever you set in nvram, do a 'nvram commit' to make it permanent. It won't survive a reboot otherwise.
(Last edited by doddel on 8 Apr 2007, 10:30)
The discussion might have continued from here.
Page 1 of 1