Hi.

I'm trying to compile Kamikaze version 7305 for AR7 (default configuration) and I got the following error:

  CC      drivers/char/pty.o
  CC      drivers/char/misc.o
  CC      drivers/char/hw_random/core.o
  LD      drivers/char/hw_random/built-in.o
  CC      drivers/char/watchdog/ar7_wdt.o
  LD      drivers/char/watchdog/built-in.o
  CC      drivers/char/ar7_gpio.o
drivers/char/ar7_gpio.c: In function 'ar7_gpio_write':
drivers/char/ar7_gpio.c:57: warning: implicit declaration of function 'gpio_set_value'
drivers/char/ar7_gpio.c:64: warning: implicit declaration of function 'ar7_gpio_disable'
drivers/char/ar7_gpio.c:68: warning: implicit declaration of function 'ar7_gpio_enable'
drivers/char/ar7_gpio.c:73: warning: implicit declaration of function 'gpio_direction_input'
drivers/char/ar7_gpio.c:78: warning: implicit declaration of function 'gpio_direction_output'
drivers/char/ar7_gpio.c: In function 'ar7_gpio_read':
drivers/char/ar7_gpio.c:94: warning: implicit declaration of function 'gpio_get_value'
drivers/char/ar7_gpio.c: In function 'ar7_gpio_open':
drivers/char/ar7_gpio.c:105: error: 'AR7_GPIO_MAX' undeclared (first use in this function)
drivers/char/ar7_gpio.c:105: error: (Each undeclared identifier is reported only once
drivers/char/ar7_gpio.c:105: error: for each function it appears in.)
make[7]: *** [drivers/char/ar7_gpio.o] Error 1
make[6]: *** [drivers/char] Error 2
make[5]: *** [drivers] Error 2

Any suggestions?

Regards.

Booboo.

Hi!

Try to delete empty "gpio.h" files

from "target/linux/ar7-2.6/files/include/asm-mips/" and
from "target/linux/ar7-2.6/files/include/asm-generic/"

then run

make target/linux-clean world

Hi.

Thanks. It works.

Regards.

Booboo.

Hi

I have a D-Link DSL-504T that I successfully loaded with a kamikaze r5428 for AR7. That was back under 2.4. I have successfully compiled a new version ( so sorry this may not be the right place to ask ) but when I load the new version onto the router I am unable to contact the router on the chosen ip address or log on to it in any way.  It still functions as a switch but I was looking to use it as a firewall.

One thing I do not know is the U-Boot Board Configuration, which may or may not be part of my problem.

Any help greatly appreciated
belljo