I installed an openWRT kamikaze on an OLD wp54g with milo tftp: it boot, but give me a VFS kernel panic: no jffs2 (the same with squashfs)
There is a way to force the board to load the filesystem? someone tried to use this board?
10x
Enrico.
enrico@w3n.it
Topic: WP54G v.1.36
The content of this topic has been archived on 6 May 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
I'm using a WP54AG. At Compex they say only squashfs filesystem is tested. I tried to build jffs2 filesystem for that board (Kamikaze r7118), but I couldn't compile it!
You can also try to contact Compex technical support. They give a good support!
Hi ilBetts,
This is exactly the same problem in this thread. http://forum.openwrt.org/viewtopic.php?id=10844
I assume that you are using the non-wrt version?
TTFN
Mike
Try to get new loader.
i encounter this problem too. but i sucessfull with new loader.
The discussion might have continued from here.
Page 1 of 1