Hello,

i'm trying to setup a multiradio network and use 1 card as AP, 1 card for mesh RX and 1 card for mesh TX(something like strix setups). But the problem is that i don't know how to limit the mesh cards one to do only TX and one to do only RX.

The best idea i can think of is something like this:

1. Get 2 omni antennas and 2 cards.
2. Plug the antennas into antenna0 on the wireless cards and leave the antenna1 plug without an antenna.
3. Set card1 TX to antenna0 and RX to antenna1 and card2 TX to antenna1 and RX to antenna0
4. Than create a bridge of this two cards

This way card1 will have strong TX signal and card2 will have strong RX signal and because they are bridged thay are going to act as one card.

I don't know if this is going to work but it makes sense to me. If someone has any documentation on this please let me know.

Regards