I flashed Kamikaze to my Buffalo WHR-G54S and installed Chillispot. I know that Chilli need its own firewall so I replace the original firewall file with chilli firewall. Unfortunately when I reboot my AP, I found I cannot access AP....even I cannot ping it... I pressed the reset button for many times, but it's useless....
Topic: SOS: Can't access AP...
The content of this topic has been archived on 29 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
Hi, I did have the some problem, yesterday.
I think the firewall conf. was the problem.
My solution was reflash the device.
You can try it if boot_wait is on.
Maybe yoy don´t want do that, because you will lost lot of job.
You can try falisafe mode too.
Good luck.
The discussion might have continued from here.
Page 1 of 1