The content of this topic has been archived on 21 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Hello,
i am trying to install Kamikaze on a Compex NP18A box.
I could not create an Image that i could flash via the webinterface, so i try to get a serial console. NP18A has an externa rs232 port, but i could not find the right settings.
Maybe anyboy knows them?
Best Regards.
At http://wiki.openwrt.org/OpenWrtDocs/Hardware/Compex/ they just say 115200 bps.
Try my WP54AG settings:
Baud rate: 115200
Data: 8 bit
Parity: None
Stop: 1 bit
Flow control: None
or ask Compex support at support@compex.com.sg.
If you gave them your serial number box, they will provide the informations you need.
thanks, i tried that settings already.
the wiki page refers to the internal serial port. so i have to install a connector on the internal.
there is a serial port outside on the casing, but it is useless according to the support.
it was one of the reasons why i decided to buy the box...
h0rus: drop me a mail..
The discussion might have continued from here.