Hi,

I own a WAP54G v1 (MDG0047) with a AM29LV320DB flash chip, reset button is right to the antenna and wireless chip on a mini-pci daughter card.
After too much play with it and various firmwares, i bricked it completely (CFE is dead) but hopefully i made a wholeflash backup when it was fine. I used the latest HairyDairy ejtag tool whith the /nobreak option. I don't know if it is supposed to work well with WAP APs without any patch, backups never hanged but i wasn't able to start the erase of the kernel without the /nobreak option.

Now, i can't flash the backup back to the router, a flash:cfe stops at "4% bytes = 12224" and a flash:wholeflash stops at "0%   bytes = 10728".
There is another post related to this problem on a v2 or v3.

So my questions are :
- Why does it stops, is the flash chip dead or the jtag tool incompatible ?
- Are there special instructions for a WAP54g ? (can't find anything)
- Does anyone have a CFE backup from a WAP54g v1 or v1.1 ??

Thank you so much

Try with
/nobreak /noreset /nocwd /noemw

Thank you Eko but it doesn't work.

I have another dead Linksys router board (overheated) with a MX29LV160AT flash chip that is pin compatible with the AM29LV320DB (and reconized by HairyDairy Debrick), unless i get other suggestions, i'll try to change the flash chip.

As last resort use Hairy's v2.2. It's damn slow, but I had more success with it.

Great ! I'm flashing the wholeflash with Hairy's v4.1 and it hasn't hang at the same point as usual... it's still running and should be done in a few hours, i keep you informed.

Thank you Eko, i was maybe about to destroy it soldering the other flash chip