Hey guys...
I am using Rodents build on my linksys v2.2 G. I am not able to control the LED's is there any work around to eb able to control the LEDs?
echo 0x00 > /proc/sys/diag
does nothing.. any ideas?
..R
Topic: Rodents build and LED's
The content of this topic has been archived on 20 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
This has been covered in the forum before. It's a bug in the diag module code that's fixed in CVS.
You can check out the new diag.c and build your own version off of Rodent's buildroot, try FreiFunk's build, or mbm's experimental build. Any of these work on the newer units, and have the diag bug fixed.
G
The discussion might have continued from here.
Page 1 of 1