Hi I have a Aterm WL5400AP . It has a ar531x rev 0x00005742 firmware startup...
the bootloader is a vxworks ,I succefully ran via TFTP (kernel) and NFS (nfsroot) Kamikaze
Now I would like to know if is possible install redboot loader? and i would like to know if is possible patition MTD because i have no partitions
root@172:/# cat /proc/mtd
dev: size erasesize name
mtd0: 00400000 00010000 "physmap-flash.0"
root@172:/#
This is what I have in the boot msg
physmap platform flash device: 00400000 at 1e000000
physmap-flash.0: Found 1 x16 devices at 0x0 in 8-bit bank
Amd/Fujitsu Extended Query Table at 0x0040
physmap-flash.0: Swapping erase regions for broken CFI table.
number of CFI chips: 1
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
cmdlinepart partition parsing not available
Sadly this board have no pins to connect a jtag adapter
thanks in advance
maximiliano
pd : this is my boot log..
Attaching network interface lo0... done.
Loading... 2579644 + 352288
Starting at 0x802d1000...
Linux version 2.6.19.2 (root@localhost.localdomain) (gcc version 4.1.2) #7 Tue Jul 17 23:20:40 ART 2007
CPU revision is: 00018009
Determined physical RAM map:
memory: 00800000 @ 00000000 (usable)
Initrd not found or empty - disabling initrd
On node 0 totalpages: 2048
DMA zone: 16 pages used for memmap
DMA zone: 0 pages reserved
DMA zone: 2032 pages, LIFO batch:0
Normal zone: 0 pages used for memmap
Built 1 zonelists. Total pages: 2032
Kernel command line: root=/dev/nfs rw nfsroot=172.16.170.248:/home/maxi/kamikaze_7.06/build_mips/root,nolock ip=dhcp debug
Primary instruction cache 16kB, physically tagged, 4-way, linesize 16 bytes.
Primary data cache 16kB, 4-way, linesize 16 bytes.
Synthesized TLB refill handler (20 instructions).
Synthesized TLB load handler fastpath (32 instructions).
Synthesized TLB store handler fastpath (32 instructions).
Synthesized TLB modify handler fastpath (31 instructions).
PID hash table entries: 32 (order: 5, 128 bytes)
Using 90.000 MHz high precision timer.
Dentry cache hash table entries: 1024 (order: 0, 4096 bytes)
Inode-cache hash table entries: 512 (order: -1, 2048 bytes)
Memory: 4984k/8192k available (2280k kernel code, 3208k reserved, 339k data, 128k init, 0k highmem)
Calibrating delay loop... 179.40 BogoMIPS (lpj=897024)
Mount-cache hash table entries: 512
Checking for 'wait' instruction... available.
NET: Registered protocol family 16
Radio config found at offset 0x2000(0x100)
NET: Registered protocol family 2
IP route cache hash table entries: 64 (order: -4, 256 bytes)
TCP established hash table entries: 256 (order: -2, 1024 bytes)
TCP bind hash table entries: 128 (order: -3, 512 bytes)
TCP: Hash tables configured (established 256 bind 128)
TCP reno registered
squashfs: version 3.0 (2006/03/15) Phillip Lougher
Registering mini_fo version $Id$
JFFS2 version 2.2. (NAND) (C) 2001-2006 Red Hat, Inc.
io scheduler noop registered
io scheduler deadline registered (default)
Serial: 8250/16550 driver $Revision: 1.90 $ 1 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0xbc000003 (irq = 37) is a 16550A
eth0: Dropping NETIF_F_SG since no checksum feature.
eth0: Atheros AR231x: 00:0d:02:47:54:57, irq 4
physmap platform flash device: 00400000 at 1e000000
physmap-flash.0: Found 1 x16 devices at 0x0 in 8-bit bank
Amd/Fujitsu Extended Query Table at 0x0040
physmap-flash.0: Swapping erase regions for broken CFI table.
number of CFI chips: 1
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
cmdlinepart partition parsing not available
Searching for RedBoot partition table in physmap-flash.0 at offset 0x3d0000
Searching for RedBoot partition table in physmap-flash.0 at offset 0x3e0000
Searching for RedBoot partition table in physmap-flash.0 at offset 0x3f0000
No RedBoot partition table detected in physmap-flash.0
ip_conntrack version 2.4 (64 buckets, 512 max) - 240 bytes per conntrack
ip_tables: (C) 2000-2006 Netfilter Core Team
TCP vegas registered
NET: Registered protocol family 1
NET: Registered protocol family 17
eth0: Configuring MAC for full duplex
Bridge firewalling registered
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
Time: MIPS clocksource has been installed.
Sending DHCP requests ., OK
IP-Config: Got DHCP answer from 0.0.0.0, my address is 172.16.170.226
IP-Config: Complete:
device=eth0, addr=172.16.170.226, mask=255.255.255.0, gw=172.16.170.254,
host=172.16.170.226, domain=, nis-domain=(none),
bootserver=0.0.0.0, rootserver=172.16.170.248, rootpath=
Looking up port of RPC 100003/2 on 172.16.170.248
Looking up port of RPC 100005/1 on 172.16.170.248
VFS: Mounted root (nfs filesystem).
Freeing unused kernel memory: 128k freed
Warning: unable to open an initial console.
Algorithmics/MIPS FPU Emulator v1.5
tmpfs: Bad value '-8192' for mount option 'size'
- preinit -
init started: BusyBox v1.4.2 (2007-07-17 18:24:49 ART) multi-call binary
Please press Enter to activate this console.
BusyBox v1.4.2 (2007-07-17 18:24:49 ART) Built-in shell (ash)
Enter 'help' for a list of built-in commands.
_______ ________ __
| |.-----.-----.-----.| | | |.----.| |_
| - || _ | -__| || | | || _|| _|
|_______|| __|_____|__|__||________||__| |____|
|__| W I R E L E S S F R E E D O M
KAMIKAZE (7.06) -----------------------------------
* 10 oz Vodka Shake well with ice and strain
* 10 oz Triple sec mixture into 10 shot glasses.
* 10 oz lime juice Salute!
---------------------------------------------------
root@172:/#
root@172:/#