The content of this topic has been archived on 15 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
i am trying to recover a LinksysWRT54G from a bad flash ,
when i type in "192.168.1.1" i get a white page with
"No webpages currently available "
- perhaps you need to install a package ?
- TFTP method does not work
- telnet does not work
any ideas ? thanks so much !!!!
************************
cpu model V0.7
boot_ver v2.1, v2.3
pmon_ver 3.51.21.0
WRT54G v2
If you're sure of your results, don't trust them, test it again, then if you've nothing left you can:
- try previous IP address you've in the past with your ap
- or try to press reset switch for a while to see what happens when ap starts again
- or open your ap, hack it to create a jtag connector and use this mode to flash up your ap with a good fw
Hope it helps
Ben
thanks ben,
well i try again ,but i never did this cable stuff before
"HairyDairyMaid_WRT54G_Debrick_Utility_v45" and do
http://wiki.openwrt.org/OpenWrtDocs/Cus … JTAG_Cable
could it be possible that nvram is not in boot wait mode or so ?
thanks anyway
http://farm2.static.flickr.com/1210/966 … 7dd1_o.jpg
(Last edited by macbroadcast on 31 Jul 2007, 23:35)
The discussion might have continued from here.
