The content of this topic has been archived on 18 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Hi,
I followed this tutorial for flashing my WLA-G54C http://wiki.openwrt.org/OpenWrtDocs/Har … o/WLA-G54C. I had used the "openwrt-brcm-2.4-squashfs.trx image". The flash was ok but the AP don´t reboot automately, I did reboot but now, I cannot ping/access.
Can anybody say me how access to AP.
I've read the tftf don´t work becasue this AP have the boot_time = off. Is it true?
Thanks.
Quiqueal
I've had few WLA-G54C in the past and boot_wait was set to on by default, so try to reset the machine, it should restore itself to buffalo default address, ping it, if it works you can tftp a safe image to it
Ben
Not in my case. After doing an erase:wholeflash and flash:cfe using JTAG it has IP 192.168.1.1 and MAC 00:00:19:78:10:05. After the next reboot the NVRAM got initialized by the CFE with boot_wait=off.
The discussion might have continued from here.