After installing Kamikaze through the web interface, I can only access my router when it's in failsafe mode. I've tried resetting the NVRAM to no avail. Can anyone shed any light on the situation.
Thanks.
Topic: WRT54GL problems
The content of this topic has been archived on 25 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
Bump.
Anyone?
So it's not there in 192.168.1.1?
Tried pinging it?
Are you telneting or attempting to load it under a web-browser?
I can't ping, telnet, or ssh outside of failsafe mode.
(Last edited by fophillips on 5 Sep 2007, 10:02)
Right fixed.
I downloaded the Linksys stock firmware, converted the bin into a trx using dd. Used wget + mtd to download of my desktop and flash. Used the stock firmware to reinstall openwrt. All is hunky dory.
The discussion might have continued from here.
Page 1 of 1