Hi everybody, there is a way to change the failsafe mode values without recompile the whole nvram??? I heard something about the firmware extractor, but dont know what file change.... some ideas???? Because I change some values but the change is permanent. I want to change the lan_ipaddr and wl_ssid values only in the failsafe mode.
Thanks you in advance....
Topic: Change the failsafe mode values
The content of this topic has been archived on 31 Mar 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
The discussion might have continued from here.
Page 1 of 1