hi
i have wgt634u with kamikaze 7.09
i use in client mode
my wireless
config wifi-device wifi0
option type atheros
option channel 5
# REMOVE THIS LINE TO ENABLE WIFI:
option disabled 0
config wifi-iface
option device wifi0
option network lan
option mode sta
option ssid linksys
option bssid 00:13:10:83:d1:cf
option encryption psk
option key 1111111111
option channel 1
My network
#### VLAN configuration
config switch eth0
option vlan0 "0 1 2 3 4 5"
#### Loopback configuration
config interface loopback
option ifname "lo"
option proto static
option ipaddr 127.0.0.1
option netmask 255.0.0.0
#### LAN configuration
config interface lan
option type bridge
option ifname "eth0.0"
option proto static
option ipaddr 192.168.1.2
option dns 192.168.1.1
option gateway 192.168.1.1
option netmask 255.255.255.0
i connect with my router dhcp server 192.168.1.1
iwconfig is ok
ath0 IEEE 802.11g ESSID:"linksys" Nickname:""
Mode:Managed Frequency:2.412 GHz Access Point: 00:13:10:83:D1:CF
Bit Rate:36 Mb/s Tx-Power:20 dBm Sensitivity=1/1
Retry:off RTS thr:off Fragment thr:off
Encryption key:50AA-BACC-010F-171B-91CB-73A6-AB67-AF66 Security mode
:restricted
Power Management:off
Link Quality=32/70 Signal level=-64 dBm Noise level=-96 dBm
Rx invalid nwid:65009 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
but when i put a pc on ethernet nothing i can't acces on my network or internet, the wgt634U have acces on network and internet but not the lan of wgt634u
Can you help me thanks