Topic: Siemens SE505 revision 2 is using odd NVRAM settings

The content of this topic has been archived on 18 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Page 1 of 1

Post #1

BratMaxxe

20 Apr 2005, 13:48

Hi,

the original NVRAM settings on SE505 revision 2 are not applicable for the OpenWRT firmware. I just got my unit working after manually erase the stuff, but it does not work out of the box.... After flashing OpenWRT you will end up without any network, needs serial console to configure and post-install.

Please have a look at http://openwrt.org/forum/viewtopic.php?id=965. This thread contains a few interresting NVRAM dumps.

Does anybody maybe have a clue what's wrong here?

Regards,
BratMaxxe

The discussion might have continued from here.

Page 1 of 1