According to the product brief of the BCM5354, the chip in the whr-g125, it has a USB 2.0 host controller. If so, couldn't a USB port be soldered to the appropriate pins on the chip and the appropriate drivers written to use the 'free' USB port?
Topic: Can you give the whr-g125 a USB port?
The content of this topic has been archived on 28 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
only if the board has a header, the same question was brought up for the wrts
The discussion might have continued from here.
Page 1 of 1