Greetings,
I have two WRT54GL. On node29, I can access every feature, web, ssh etc.
P O L A R I S 0 . 2 . 1
S O U S
F R E I F U N K F I R M W A R E
1.610
On the new one (node31) than I can access by bouncing by ssh from node 29, I have 1.45 (i think) I need to flash the firmware and be able to use the web interface from my LAN.
root@node31:~# ifconfig
eth0 Link encap:Ethernet HWaddr 00:1A:70:FD:4B:72
UP BROADCAST RUNNING PROMISC MULTICAST MTU:1500 Metric:1
RX packets:532 errors:0 dropped:0 overruns:0 frame:0
TX packets:2 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:85811 (83.7 KiB) TX bytes:2094 (2.0 KiB)
Interrupt:4
eth1 Link encap:Ethernet HWaddr 00:1A:70:FD:4B:74
inet addr: 10.76.3.193 Bcast:10.76.255.255 Mask:255.255.0.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:473 errors:0 dropped:0 overruns:0 frame:3181
TX packets:746 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:37446 (36.5 KiB) TX bytes:64126 (62.6 KiB)
Interrupt:2 Base address:0x5000
lo Link encap:Local Loopback
inet addr: 127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:9 errors:0 dropped:0 overruns:0 frame:0
TX packets:9 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:939 (939.0 B) TX bytes:939 (939.0 B)
vlan0 Link encap:Ethernet HWaddr 00:1A:70:FD:4B:72
inet addr:192.168.3.193 Bcast: 192.168.3.223 Mask:255.255.255.224
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Here is the config of node29 :
http://192.168.0.62/cgi-bin/state/index.html
Status : Configuration Générale
Adresse IP : IP: 10.76.3.129, Masque sous réseau: 255.255.0.0, MAC: 00:1c:10:14:09:ea
Etat sans fil : SSID: "rouen-wireless.net" Mode: Ad Hoc RSSI: -76 dBm noise: -87 dBm Channel: 3 BSSID: DA:99:78:CA:FD:2E Capability: None Supported Rates: [ 1(b) 2(b) 5.5(b) 6 9 11(b) 12 18 24 36 48 54 ]
Temps de fonctionnement : 07:21:27 up 4 days, 12:26, load average: 0.31, 0.27, 0.10
Informations sur l'AP : Boardtype: 0x0467, Boardnum: 42
Voisines : IP Hysteresis LinkQuality lost total NLQ ETX
10.76.3.193 0.00 0.68 32 100 0.82 1.79
Kernel Log : Afficher / Masquer
Creating 5 MTD partitions on "Physically mapped flash":
0x00000000-0x00040000 : "cfe"
0x00040000-0x003f0000 : "linux"
0x000b617c-0x002c0000 : "rootfs"
mtd: partition "rootfs" doesn't start on an erase block boundary -- force read-only
0x003f0000-0x00400000 : "nvram"
0x002c0000-0x003f0000 : "OpenWrt"
diag boardtype: 00000467
Probing device eth0: found!
eth1: Broadcom BCM4320 802.11 Wireless Controller 3.90.37.0
Software Watchdog Timer: 0.05, timer margin: 180 sec
CSLIP: code copyright 1989 Regents of the University of California
PPP generic driver version 2.4.2
IP NAT : Afficher / Masquer
Chain PREROUTING (policy ACCEPT 47451 packets, 7556K bytes)
pkts bytes target prot opt in out source destination
3374 281K WiFiDog_Outgoing all -- eth1 * 0.0.0.0/0 0.0.0.0/0
Chain POSTROUTING (policy ACCEPT 674 packets, 46130 bytes)
pkts bytes target prot opt in out source destination
247 67485 MASQUERADE all -- * * 10.76.3.128/27 0.0.0.0/0
57689 2320K MASQUERADE all -- * vlan1 0.0.0.0/0 0.0.0.0/0
Chain OUTPUT (policy ACCEPT 58589 packets, 2427K bytes)
pkts bytes target prot opt in out source destination
Chain WiFiDog_AuthServers (1 references)
pkts bytes target prot opt in out source destination
501 27276 ACCEPT all -- * * 0.0.0.0/0 88.191.45.2
Chain WiFiDog_Global (1 references)
pkts bytes target prot opt in out source destination
0 0 ACCEPT udp -- * * 0.0.0.0/0 69.90.89.192/27
0 0 ACCEPT udp -- * * 0.0.0.0/0 69.90.85.0/27
0 0 ACCEPT tcp -- * * 0.0.0.0/0 80.245.57.139 tcp dpt:80
0 0 ACCEPT all -- * * 0.0.0.0/0 88.191.45.2
0 0 ACCEPT udp -- * * 0.0.0.0/0 213.11.62.39
0 0 ACCEPT udp -- * * 0.0.0.0/0 62.39.136.151
0 0 ACCEPT udp -- * * 0.0.0.0/0 212.27.52.5
0 0 ACCEPT udp -- * * 0.0.0.0/0 213.91.9.210
1170 91378 ACCEPT all -- * * 0.0.0.0/0 10.0.0.0/8
Chain WiFiDog_Outgoing (1 references)
pkts bytes target prot opt in out source destination
380 27303 WiFiDog_WIFI2Router all -- * * 0.0.0.0/0 10.76.3.129
2994 254K WiFiDog_WIFI2Internet all -- eth1 * 0.0.0.0/0 0.0.0.0/0
Chain WiFiDog_Unknown (1 references)
pkts bytes target prot opt in out source destination
2994 254K WiFiDog_AuthServers all -- * * 0.0.0.0/0 0.0.0.0/0
2493 227K WiFiDog_Global all -- * * 0.0.0.0/0 0.0.0.0/0
390 21776 REDIRECT tcp -- eth1 * 0.0.0.0/0 0.0.0.0/0 tcp dpt:80 redir ports 2060
Chain WiFiDog_WIFI2Internet (1 references)
pkts bytes target prot opt in out source destination
0 0 REDIRECT tcp -- * * 0.0.0.0/0 0.0.0.0/0 tcp dpt:80 MARK match 0x2 redir ports 8888
0 0 ACCEPT all -- * * 0.0.0.0/0 0.0.0.0/0 MARK match 0x3
0 0 ACCEPT all -- * * 0.0.0.0/0 0.0.0.0/0 MARK match 0x1
2994 254K WiFiDog_Unknown all -- * * 0.0.0.0/0 0.0.0.0/0
Chain WiFiDog_WIFI2Router (1 references)
pkts bytes target prot opt in out source destination
380 27303 ACCEPT all -- eth1 * 0.0.0.0/0 0.0.0.0/0
nterface de Configuration : Afficher / Masquer lan_ifnames=vlan0
lan_ifname=vlan0
wl0_ifname=eth1
wifi_ifname=eth1
wan_ifname=vlan1
bridge name bridge id STP enabled interfaces
1: lo: mtu 16436 qdisc noqueue
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
2: eth0: mtu 1500 qdisc pfifo_fast qlen 1000
link/ether 00:1c:10:14:09:e8 brd ff:ff:ff:ff:ff:ff
3: eth1: mtu 1500 qdisc prio qlen 1000
link/ether 00:1c:10:14:09:ea brd ff:ff:ff:ff:ff:ff
inet 10.76.3.129/16 brd 10.76.255.255 scope global eth1
4: vlan0: mtu 1500 qdisc noqueue
link/ether 00:1c:10:14:09:e8 brd ff:ff:ff:ff:ff:ff
inet 192.168.3.129/27 brd 192.168.3.159 scope global vlan0
5: vlan1: mtu 1500 qdisc noqueue
link/ether 00:1c:10:14:09:e8 brd ff:ff:ff:ff:ff:ff
inet 192.168.0.62/24 scope global vlan1
NVRAM de Configuration : Afficher / Masquer ff_bmf=1
ff_bssid=DA:99:78:CA:FD:2E
ff_dnsmasq=1
ff_fisheye=0
ff_hna4=0.0.0.0/0
ff_httpinfo=1
ff_lan_proto=1
ff_nameservice=1
ff_nonat=1
ff_nonetmsg=0
ff_olsrtc=1
ff_qoslev=2
ff_reset=4416900dd5f46795a6070dc9672a585c
ff_rfisheye=1
ff_tz=MET-1MEST-2,M3.3.0,M10.5.0
ff_unsecure_webadmin=1
ff_wanhttp=1
ff_wanicmp=1
ff_wanssh=1
ff_wifi_proto=1
ff_wl_dhcp_lease=21600
ff_wl_dhcp_num=29
ff_wl_dhcp_start=130
ff_wldhcp=10.76.3.128/27,255.255.255.224
wifi_ifname=eth1
wifi_ipaddr=10.76.3.129
wifi_netmask=255.255.0.0
wifi_proto=static
wl0_active_mac=
wl0_afterburner=off
wl0_akm=
wl0_antdiv=0
wl0_ap_isolate=0
wl0_auth=0
wl0_auth_mode=none
wl0_bcn=100
wl0_channel=3
wl0_closed=0
wl0_corerev=9
wl0_country=Worldwide
wl0_country_code=FR
wl0_crypto=tkip
wl0_distance=
wl0_dtim=1
wl0_frag=512
wl0_frameburst=off
wl0_gmode=0
wl0_gmode_protection=off
wl0_hwaddr=
wl0_ifname=eth1
wl0_infra=0
wl0_lazywds=1
wl0_mac_deny=
wl0_mac_list=
wl0_maclist=
wl0_macmode1=disabled
wl0_macmode=disabled
wl0_maxassoc=128
wl0_mode=sta
wl0_mrate=0
wl0_net_mode=mixed
wl0_net_reauth=36000
wl0_passphrase=
wl0_phytype=g
wl0_phytypes=g
wl0_plcphdr=long
wl0_radio=1
wl0_radioids=BCM2050
wl0_radius_ipaddr=
wl0_radius_port=1812
wl0_rate=11000000
wl0_rateset=12
wl0_rts=250
wl0_ssid=rouen-wireless.net
wl0_txant=0
wl0_txpwr=66
wl0_unit=0
wl0_wds=
wl0_wds_timeout=1
wl0_wme=off
wl0_wme_ap_be=15 63 3 0 0 off
wl0_wme_ap_bk=15 1023 7 0 0 off
wl0_wme_ap_vi=7 15 1 6016 3008 off
wl0_wme_ap_vo=3 7 1 3264 1504 off
wl0_wme_no_ack=off
wl0_wme_sta_be=15 1023 3 0 0 off
wl0_wme_sta_bk=15 1023 7 0 0 off
wl0_wme_sta_vi=7 15 2 6016 3008 off
wl0_wme_sta_vo=3 7 2 3264 1504 off
----------------------------------------
I need some help to add a route or some feature to get node31 reachable from the LAN in 192.168.0.0 with a GW of 192.168.0.34
Do I need to open another topic to get my ISP DNS in both nodes?
Cheers and enjoy your week end :-)
Jimmy