OpenWrt Forum Archive

Topic: Help with Chilli interfaces?!

The content of this topic has been archived on 27 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Post #1
anttu
28 Nov 2007, 15:13

Please help me with the interfaces of Kamikaze and Chillispot in Meraki.

I have tried pretty much everything but I cannot make it work. My PC gets IP-address from Chilli, but then gets directly to net or then does not go anywhere. The splash page persistently stays out of my reach. The page itself works OK when connected directly with the browser.

I know that I should somehow separate eth0 and ath0 to get them connected by Chilli only, but cannot find the trick. Somebody please help me out, as I have spent a very long time to this and I am pretty close to desperate here.

Post #2
ggp81
29 Nov 2007, 10:47

Are you using 7.09? If yes, maybe that's just an Iptables problem..

(Last edited by ggp81 on 29 Nov 2007, 10:48)

Post #3
anttu
1 Dec 2007, 08:35

Thanks, I am using 7.09.

Should I downgrade to... which build? Or is there some other known workaround?

Now I have also noticed that brctl does not save the changes in bridging. The changes do take place but they are lost after restart. Any ideas about that?

The discussion might have continued from here.