Hi,

On my router Asus with WhiteRussian 0.9, I see my hard drive only if I start first the hardrive and few second later the routeur

root@OpenWrt:~# fdisk -l

Disk /dev/scsi/host0/bus0/target0/lun0/disc: 500.1 GB, 500107862016 bytes
255 heads, 63 sectors/track, 60801 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes

                                 Device Boot      Start         End      Blocks   Id  System
/dev/scsi/host0/bus0/target0/lun0/part1   *           1        1275    10241406   83  Linux
/dev/scsi/host0/bus0/target0/lun0/part2            1276        2550    10241437+  83  Linux
/dev/scsi/host0/bus0/target0/lun0/part3            2551       60546   465852870    5  Extended
/dev/scsi/host0/bus0/target0/lun0/part4           60547       60801     2048287+  82  Linux swap / Solaris
/dev/scsi/host0/bus0/target0/lun0/part5            2551        3825    10241406    b  W95 FAT32
/dev/scsi/host0/bus0/target0/lun0/part6            3826       60546   455611401    b  W95 FAT32

Disk /dev/scsi/host1/bus0/target0/lun0/disc: 1006 MB, 1006632960 bytes
65 heads, 32 sectors/track, 945 cylinders
Units = cylinders of 2080 * 512 = 1064960 bytes

                                 Device Boot      Start         End      Blocks   Id  System
/dev/scsi/host1/bus0/target0/lun0/part1   *           1         946      983024    b  W95 FAT32
Partition 1 has different physical/logical endings:
     phys=(960, 64, 32) logical=(945, 14, 32)

If I stop the harddrive and start it (without stop the router) ,the partition of the routeur are not seen
any idea ?

Regards

sapona

Hello

I've really no idea about this problem

=> method 1
a) the router Asus wl 500gp is on
b) I unplug the harddrive from the routeur (the hd is off)
c) I start the harddrive
d) I connect the hd to the routeur
e) the hd works fine ( I check with fdisk -l )
ok with this method, but I've to unplug and plug the hardrive

=> method 2
a) the router Asus wl 500gp is on
b) I stop the harddrive (without unplug it)
c) I start the harddrive again
d) I plug it
=> the hardrive is not seen (with fdisk -l)

I've OpenWRT WhiteRussian 0.9 (Linux OpenWrt 2.4.30)

Somebody could help me please ?

How could I force the usb harddrive detection after an off/on cycle ... or should I try kamikaze 7.09 with 2.6 kernel, but a full reintallation is needed

Regards

sapona