OpenWrt Forum Archive

Topic: Does KAMIKAZE(r10140) support channel selection for adhoc mode?

The content of this topic has been archived on 2 May 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Post #1
icyqqboy
9 Mar 2008, 14:59

I have meshbox installed Kamikaze7.09, by default , I set the wifi working in adhoc mode operating in channel 1,but it is not enough, I hope it is adaptive. How can I make it scan which channels the neighboring nodes are operating and adjust the operating channel with others? Are there any package already existed for this functionality ?

Thanks in advance.

Post #2
icyqqboy
9 Mar 2008, 15:03

forget to mention it is an Atheros wifi card.

The discussion might have continued from here.