ok...
i soldered the header...
installed the giveio.sys...
started the service...
and now I'm not really sure what to do.
I read the horrible documentation, and decided to first go with the following command: wrt54g -backup:nvram
Here's what going on now....
====================================
WRT54G/GS EJTAG Debrick Utility v4.5
====================================
Probing bus ... Done
Instruction Length set to 8
CPU Chip ID: 00000101001101010010000101111111 (0535217F)
*** Found a Broadcom BCM5352 Rev 1 CPU chip ***
- EJTAG IMPCODE ....... : 00000000100000000000100100000100 (00800904)
- EJTAG Version ....... : 1 or 2.0
- EJTAG DMA Support ... : Yes
Issuing Processor / Peripheral Reset ... Done
Enabling Memory Writes ...
Now it's been sitting here for 5 minutes. Not entirely sure what it's doing, if anything.
Anyone got some knowledge?