Hi group,
I have been trying to figure out how to make my WRT54Gs into a wireless bridge.
I have some WAP45Gs that do this very well but I could not get settings out of them
because I could not ssh into them. So I upgraded the firmware on one WAP with
OpenWRT. That worked, kind of! I could ssh into it, but there was no WEB interface.
If I tried to do any changes, I got 'no space on device'.

  I tweaked it so much now, I can't get into it anymore.  It will boot but can't do anything with it. It will do the tftp upload but then does not complete the reimaging. There are no
open ports anymore (nmap).

  I think what I need is a way of clearing the file system? Does the hard reset used on the
WRTs work with a WAP? Or is there an image that I can upload that will clear the disk?

  I don't need to worry about the warranty, it's 3 years old.

  Thanks for your time.