OpenWrt Forum Archive

Topic: Problem with WRT150N

The content of this topic has been archived on 6 May 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Post #1
king_of_tuxland
2 May 2008, 19:45

Hello,

i installed the kamikaze branch on my WRT150N including the X-WRT extension, there was no problem the last few days. Now i reconfigured my wireless settings, and after this the configure process started but the router hangs up. After reboot, there is no way to log in. I can't access the router configuratio Interface with the old IP or the factory default (192.168.1.1). I've tried to log on via ssh, but it says, there is no client with this IP.
If plugged my laptop to the router, there is a dhcp process, and laptop become a IP in this format: 169.254.221.218.

Now the question. Is there a way, to reset all configuration process in the openwrt firmware, or a way to log on, because i don't know the IP of the router...

Thank you

Post #2
Davidkra
2 May 2008, 20:31

That IP is a IPv4-APIPA IP. Means: DHCP is not running.

The discussion might have continued from here.