I'm working with a Asus WL500 G; using KAMIKAZE (7.09). To test USB-storage I used an old 128 MB SD card in a SD-card to USB-coverter which worked perfectly. Since 128 MB is not enough, I bought an Emtec 4 GB USB-stick. Too bad, I cannot get it to work. As soon as I connect the USB-stick; I get (dmesg):
/dev/scsi/host1/bus0/target0/lun0:usb_control/bulk_msg: timeout
usb-ohci.c: unlink URB timeout
The USB-stick is perfectly running on other Linux systems, both USB 1 and USB2.
Anyone familiar with this problem?
Kind regards,
Langeman
dmesg info:
usb-ohci.c: USB OHCI at membase 0xb8004000, IRQ 2
usb-ohci.c: usb-00:04.0, PCI device 14e4:4715
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
SCSI subsystem driver Revision: 1.00
hub.c: new USB device 00:04.0-1, assigned address 2
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
USB Mass Storage support registered.
scsi0 : SCSI emulation for USB Mass Storage devices
Vendor: Generic Model: 2.0 Reader -SD Rev: 1.00
Type: Direct-Access ANSI SCSI revision: 02
Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0
SCSI device sda: 250880 512-byte hdwr sectors (128 MB)
sda: Write Protect is off
Partition check:
/dev/scsi/host0/bus0/target0/lun0: p1
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 2
kjournald starting. Commit interval 5 seconds
EXT3-fs warning: maximal mount count reached, running e2fsck is recommended
EXT3 FS 2.4-0.9.19, 19 August 2002 on sd(8,1), internal journal
EXT3-fs: mounted filesystem with ordered data mode.
usb.c: USB disconnect on device 00:04.0-1 address 2
hub.c: new USB device 00:04.0-1, assigned address 3
scsi1 : SCSI emulation for USB Mass Storage devices
Vendor: Model: USB DISK 2.0 Rev: PMAP
Type: Direct-Access ANSI SCSI revision: 02
Attached scsi removable disk sdb at scsi1, channel 0, id 0, lun 0
SCSI device sdb: 7708672 512-byte hdwr sectors (3947 MB)
sdb: Write Protect is off
/dev/scsi/host1/bus0/target0/lun0:usb_control/bulk_msg: timeout
usb-ohci.c: unlink URB timeout