OpenWrt Forum Archive

Topic: Cannot access bridged network

The content of this topic has been archived on 29 Mar 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Post #1
kazol_
24 Jun 2008, 05:01

I have a main router/AP (running openwrt) on the 192.168.1.x subnet which wifi signal is received by another router running dd-wrt (I have no choice due to the low flash memory) on 192.168.2.x as client mode.

Unfortunately, I cannot connect to the printers connected to the dd-wrt router on 2.x (from 1.x), but everything else works ok (I can connect to the 1.x subnet from 2.x without problem).

Any ideas?

Post #2
MMCM
24 Jun 2008, 08:03

The dd-wrt router is the wifi client? Do you use NAT on dd-wrt? Or plain routing? Are default gateways setup correctly on all devices on both sides?

The discussion might have continued from here.