OpenWrt Forum Archive

Topic: How to build yealink phone driver?

The content of this topic has been archived on 7 May 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Post #1
ghliaw
15 Jul 2008, 10:02

I have a WL-500g and downloaded kamikaze 7.09. In menuconfig. I made the following selection:

Target System (Broadcom BCM947xx/953xx [2.6])
Kernel Modules --> USB Support --> kmod-usb-yealink

After finishing compilation and installation on the target system, I could not find the driver of yealink phone.

I tried re-build the whole system again, but still could not find.

Could someone help me?

Thanks a lot.

Post #2
alexsamad
17 Jul 2008, 03:42

did you make it a module or compile in ?

have a look in your build tree see if it exists there

The discussion might have continued from here.