OpenWrt Forum Archive

Topic: Can't flash my WAG354G with AR7 Port

The content of this topic has been archived on 26 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Hello

I have a Linksys WAG354G v1 AnnexA router. I wanted to install OpenWRT with X-WRT, so I tried to flash using TFTP with snapshots.
The files are successfully uploaded on the router, but when it restarts the power LED is blinking red/green forever.
I tried all the WA31 snapshots from 17-Aug-2008, I always have the same problem. If I flash back to the original firmware using TFTP, everything goes fine!

Can someone explain me what goes wrong?

Thank you! wink

Edit :
On this page the was already the same problem but no solution : http://lists.openwrt.org/pipermail/open … 00044.html

(Last edited by XK on 21 Aug 2008, 04:08)

The discussion might have continued from here.