OpenWrt Forum Archive

Topic: xwrt - "No configuration changes were made" error

The content of this topic has been archived on 1 May 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

I have:

openwrt rev: OpenWrt Kamikaze bleeding edge, r11979
image: openwrt-wrt54g-2.4-squashfs.bin
device: on a WRT54G
Xwrt rev: r4428

and I can't save any settings? most of the time the settings aren't listed as changed, when they are and I click apply it says: "No configuration changes were made"

I probably should say this on a xwrt forum, but I am unsure if its xwrt (probably) or open wrt.

any ideas?

(Last edited by smellymoo on 22 Aug 2008, 12:17)

smellymoo wrote:

I have:

openwrt rev: OpenWrt Kamikaze bleeding edge, r11979
image: openwrt-wrt54g-2.4-squashfs.bin
device: on a WRT54G
Xwrt rev: r4428

and I can't save any settings? most of the time the settings aren't listed as changed, when they are and I click apply it says: "No configuration changes were made"

I probably should say this on a xwrt forum, but I am unsure if its xwrt (probably) or open wrt.

any ideas?

First you must save.

now that's just being mean. of cause I clicked save changes. I have 2 routers on x-wrt, and I have been using it for a while, this is only happening on the bleeding edge release router which I like to experiment with and I only use.

The discussion might have continued from here.