Hello, I'd like to get some help installing OpenWrt on a SMC WEBT-G.
It has the almost same hardware as the FON2100, but with VxWorks so I have no idea where should I start.

I've got it currently connected to via serial.
Should I change the bootloader to something else, how and what? Or is it possible and easier to use VxWorks' bootloader? And how would that work?

The device is now in the console mode:
====== console mode ======
  shift-0: enable debug
  g      : mini-loader
  ENTER  : show this help
==========================

And I could use mini-loader to upload the image

[Mini Loader - image must start at 0x80001000]
TFTP Server IP address [192.168.1.100]:
Filename [soho_ap_050105.zip]:

I can also boot it to the bootloaders menu:

[WA4001C Boot]:

======================
[u] Upload to Flash
[E] Erase Flash
[M] Upload to Memory
[R] Read from Memory
[W] Write to Memory
[T] Memory Test
[Y] Go to Memory
[G] Run Runtime Code
[A] Set MAC Address
[#] Set Serial Number
[V] Set Board Version
[P] Print Boot Params
[0] ALERT LED Off
[1] ALERT LED On
[2] WLAN LEDs Off
[3] WLAN LEDs On
[4] Ethernet LED On
[C] Set Country Code
[b] Reboot
======================

Upload:
UPLOAD Flash
--------------------------------------
      Area         Address     Length
--------------------------------------
[0] Boot          0xBFC00000     128K
[1] Configuration 0xBFC20000     128K
[2] Web Image     0xBFC40000    1152K
[3] Code Image    0xBFD60000     576K
[4] Params Area   0xBFDF0000      64K
--------------------------------------
[9] Firmware      **********   ******
--------------------------------------
Enter area to UPLOAD:

I can also get to the debug console:
======= Console Debug =======
(1)   Alert Mail Testing
(2)   Web Upgrage
(3)   Write Web
(4)   Firmware Upgrage
(5)   Write Firmware
(6)   Warm Reboot
(7)   Get Operating Mode
(8)   Show B0,B1 Mem pool
(9)   All LEDs ON
(0)   All LEDs OFF
(a)   <MENU> gConfig
(b)   <MENU> gSetting
(c)   <MENU> DHCP Client
(e)   <MENU> Ethernet
(s)   <MENU> System
(w)   <MENU> Wireless
(x)   Exit
(y)   Show Reg 0xA0
(?)   Help
=============================
[Debug]:

Now, what should I do first?

I'd really appreciate any help on this, thanks.

(Last edited by DESiBELi on 6 Oct 2008, 18:04)