If you want to see USB Support you must enable in kernel_menuconfig:
* Bus options
** Support for PCI controller
Also to see that you must enable any other board type besides br6104k(p).
(Last edited by LAR on 29 Oct 2010, 19:26)
The content of this topic has been archived between 7 Oct 2014 and 5 May 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
If you want to see USB Support you must enable in kernel_menuconfig:
* Bus options
** Support for PCI controller
Also to see that you must enable any other board type besides br6104k(p).
(Last edited by LAR on 29 Oct 2010, 19:26)
Following this guide I built my distro for my Omnima's boards. Binaries and description are available on my website http://www.valeriovaccaro.it/wordpress/ … t/?lang=en
The discussion might have continued from here.