hi,I'm a newer and i don't have any knowledge of program.
now my router is down now, it's Huawei WA1003A-RU, the chip is TI 7300 flash:AT49BV322A NetChip IP175C,i try to use the software JTAG.exe re-flash it, but the application can not support the flash chip, does some one help me solve this problem?
or does someone help to program a new version make it support my flash chip (AT49BV322A).
thanks in advance!
----error information----------------------------------
===============================================
Broadcom EJTAG Debrick Utility v1.6r-hugebird
===============================================
Probing bus ... Done
Instruction Length set to 5
CPU running under BIG endian
CPU Chip ID: 00000000000000000001000000001111 (0000100F)
*** Found a TI AR7WRD TNETD7300GDU Rev 1 CPU chip ***
- EJTAG IMPCODE ....... : 01000001010000000100000000000000 (41404000)
- EJTAG Version ....... : 2.6
- EJTAG DMA Support ... : No
- EJTAG Implementation flags: R4k DINTsup ASID_8 NoDMA MIPS32
*** DMA Mode Forced On ***
Issuing Processor / Peripheral Reset ... Done
Enabling Memory Writes ... Skipped
Halting Processor ... <Processor did NOT enter Debug Mode!> ... Done
Clearing Watchdog ... Done
Loading CPU Configuration Code ... Skipped
Manual Flash Selection ... *** Unknown or NO Flash Chip Selected ***
*** REQUESTED OPERATION IS COMPLETE ***