i just installed openwrt on my dir-300 and it seems to work well...

but i can't find where i can set wan on Luci.

is there anyone who let me know how to set wan?

Actually, i know almost nothing about linux...

(i just used dd-wrt, and i just changed it to openwrt to use vpn...)

(i tried it with x-wrt, but i can't find "wan" setting part on webif, either.)

Hi.

The current release and trunk of openwrt do not support the switch in the dir-300, therfore you see no wan interface to configure.
To get support for the programmable switch in the dir-300 you have to apply some patches yourself, see:
http://inst.eecs.berkeley.edu/~pathorn/ip175c/phylib/

~ JoW

And the DIR-300 goes unstable on high traffic...

even with 8.09? :'(

(and do i have to build openwrt to apply that patch?)

Does anyone have a binary version of a patched kamikaze for the dlink dir-300?

Hi.

Yes, here: http://dev.luci.freifunk-halle.net/frei … s/atheros/

It's intended for OLSR meshing but can be used as normal firmware as well - just don't enable the strange stuff

Edit: hostapd isn't included, so you have to install it with opkg.

~ JoW

(Last edited by jow on 24 Mar 2009, 19:15)