Dear Forum,

I'm pretty new to OpenWRT, even not to Linux.
What I have:
- 1x wg302V1 running kamikaze 8.09 with webif
- 1x wg302V2 running kamikaze 8.09 with webif
- An Ethernet-backbone between this two devices.
- A building with to floors, which I have to cover with the APs ;-)

What I want:
- Separating the WLAN from my LAN by VLAN.
- Use the internal DHCPd on one of the wg302 with fixed IP-addresses

What I did:
- I have read the doc "Networkinterfaces" on wiki.openwrt.org
- At first I configured one wg302 as a normal AP and connected my iphone per wifi with this device

What I don't know (because the docs refers to another HW):
- How are the ports vlans numbered on a wg302?
- What is the port number of the internal switch on my wg302?
- How can I check these things on my own?
- What is the best solution, for covering the two floors?

Many, many thanks in advance!

Greetz
Stevie