@ all user

my problem...this is a good question...

i start to describe my problem correctly:

this is the howto which i found ---> http://forum.openwrt.org/viewtopic.php?id=11536

what i did at last:
- new fresh installation of everythin
- no changes on the config files

WRT54GLv11 (Router)
- installed the latest openwrt white russian 0.9 firmware on the WRT54GL
- updated the ipkg list
- installed this pkg: chillispot; freeradius-mod-pap; freeradius-mod-sql-mysql; openntpd; ntpclient
LAN:

IP: 192.168.0.1
SN: 255.255.255.0

WAN:

IP: 192.168.XX.XX (this ip is config. in the firewall to connect the freeradiusserver)
SN: 255.255.255.XXX
GW: 192.168.XX.X
DNS: 213.139.XXX.X

WRT54GSv4 (WDS Repeater)
- installed the latest openwrt white russian firmware 0.9 on the WRT54GSv4
- updated the ipkg list

debian test client
- installed debian lenny
- installed apache2; php5
- updated pkg list
Network Interface:

address 192.168.X.XX
netmask 255.255.255.XXX
network 192.168.X.X
broadcast 192.168.X.XXX
gateway 213.139.X.X

freeradius server
- the freeradius is in our computer center a few miles away
Network Interface:

address 192.168.XX.X

radtest from WRT54GL to FreeRADIUS Server:

Sending Access-Request of id 24 to 192.168.XX.X:1812
        User-Name = "user"
        User-Password = "pass"
        NAS-IP-Address = coovaap
        NAS-Port = 10
        Framed-Protocol = PPP
rad_recv: Access-Accept packet from host 192.168.XX.X:1812, id=24, length=20

[size=24]what infos do you still need?
what should i do next?
where is my mistake?[/size]

(Last edited by Y_to_da_E on 15 Apr 2009, 13:53)