Hi community,
we would like to introduce new router supporting OpenWRT.
It is only in development stage and we are looking for community opinion regarding its features and possibilities. There still currently a chance to change something and take into community response.
This board is referenced to low-cost and low-power solutions.
Any comments and opinions are very welcome!
Below are preliminary specifications:
PCB form factor: Pico-ITX (10cm x 7.2cm, fanless)
Onboard CPU: Cortina Systems CS3516 (300Mhz ARM9 Core)
Onboard DDR SDRAM: 128Mb 333Mhz 32bit
Onboard NAND FLASH: 128Mb (or more)
Onboard LAN: 2x 10/100Mbps Ethernet
Onboard SATA: 2x SATA
Onboard connectors: 2x SATA, 2x mini-PCI slots, 1x mini-PCI Express (with USB 2.0 interface), 1x UART, 1x Pico-ITX power, 1x JTAG, GPIO ports
Back panel connectors: 2x RJ-45 LAN, 2x USB 2.0, 3x antenna (GSM, 3G, Wifi, Wimax, other), 1x RS232
Management: Watch Dog Timer, Brown-out Reset, RTC with battery
Operating system: OpenWRT with newest 2.6 Linux Kernel.
Bootloader: U-boot
gratefully,
Linkodas team