Hi to all,

Since i'm new to this all i need all the information i can get, so please help me.

I have two DWL-7100's and one is has a damaged firmware as you can see i have readout with a MAX232 JTAG Cable with Hyper Terminal:

Pinout of the serial port JP2:

( ) TX
( ) GND
( ) Vcc

( ) RX

This is what is see when it's booting:

WAP-D15   Boot Procedure                       V1.0
---------------------------------------------------------
  Start ..Boot.B12..Please check the ethernet cable on port 0

Atheros AR5001AP default version 3.0.0.43A


0
auto-booting...

Attaching to TFFS... done.
Loading /fl/APIMG1...

  Please wait, loading  image ...

  image check fail!!!


error loading file: status = 0x3d0001.

Error loading RUNTIME file: errno = 0xd0003.
Loading /fl/backup...
Cannot open "/fl/backup".

Error loading BACKUP file: errno = 0xd0003.
Can't load boot file!!

ar531x rev 0x00005742 firmware startup...
SDRAM TEST...PASSED

16x mode!



  WAP-D15   Boot Procedure                       V1.0
---------------------------------------------------------
  Start ..Boot.B12..Please check the ethernet cable on port 0

And so on and on....

Can readout the image of my other DWL-7100AP with a utility and flash this image to bricked DWL-7100 AT49BV322A chip?

As i'm new to this all, can someone tells me what tools i need and what to do?

I use a Windows system, is that a problem?

Please advice me.

Thanks in advance for any awnsers!

Regards,
Vaako