Hi,

I have UBIQUITI ROUTER STATION board.

Since I am unfamiliar with KAMIKAZE, I don’t now haw correctly put OS in station.

I need help to load OS with a step by step procedure.

Shall I have to connect the board to serial port?

OR can I use default eth port (192.168.1.20 )for loading the OS ??

Some help please for which I shall be thankful.

Regards

Andrey N-tema servis
Ukraine

Have a look at http://wiki.ubnt.com/wiki/index.php/Rou … e#Overview. There are also some hints in http://forum.ubnt.com/forum/viewtopic.php?t=9631.

FWIW I have one of these but I can only get the POE port to talk on ethernet. I sent a message to the ubnt forum asking for help last week but so far no answer. I also sent a message to ubnt support and below is part of their response:

"I do apologize for the inconvenience, but we are not developing OpenWrt software nor processing any "deep level" documentation regarding this open source product as this is really out of scope of our competence."

IMO this is poor as one of the reason I got this board is because it came with openwrt pre installed. I guess the problem is that no where does it say that it will actually work. :-(

Hope this helps,

Regards,

Tom

Here are some pointers that may be useful:

RouterStation OpenWRT SW Setup Guide
Flashing UBNT RouterStation (Openwrt forum)
Flashing UBNT RouterStation (Ubiquiti forum)
FreeBSD on UBNT RouterStation
Flash UBNT RouterStation using mtd
UBNT where is the Redboot source?
RouterStation Beta Firmware Change log
jffs for UBNT RouterStation

(Last edited by acoul on 23 May 2009, 19:24)

How i can put OS in it i dont now