So I have two buffalo whr-g54s routers that I upgraded from white russian to kamikaze via the web interface. Now they don't seem to load completely. I can ping their ip addresses and successfully tftp new images to them, but they never seem to fully boot. I can't access them via telnet, ssh or the web interface. Did I brick these guys?
Topic: Upgraded buffalo whr-g54s from white russian via web interface
The content of this topic has been archived on 29 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
If you can ping them and you can reflash them then they are not bricked. I don't know what the problem is though. If you can't figure it out reflash them with white russian.
I can successfully tftp kamikaze, white russian and I even tried dd-wrt. They all transfer without error. I can always ping the default ip. But I can't telnet, ssh or browse to it via web. It's like the images are getting transferred, but not loading. Is there any way I can take them back to factory defaults and try again? I've tried holding the init button for more than 30 seconds and letting it come back up, but I still get the same behaviour. TFTP looks good, but never seems to fully load....
The discussion might have continued from here.
Page 1 of 1