OpenWrt Forum Archive

Topic: install 8.09 in linksys wrt600n

The content of this topic has been archived on 15 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Post #1
velizarov
26 May 2009, 11:52

I'm firmwared openwrt-brcm47xx-squashfs.trx in linksys wrt600n. Device firmwared, but after reboot, it again turned to standby firmware. That this can be done?

Post #2
velizarov
27 May 2009, 06:04

up

Post #3
velizarov
29 May 2009, 07:39

up

Post #4
vincentfox
29 May 2009, 08:19

Cannot understand question so cannot answer it.

Post #5
velizarov
29 May 2009, 16:10
vincentfox wrote:

Cannot understand question so cannot answer it.

I install image openwrt-brcm47xx-squashfs.trx (with snapshot) in linksys wrt600n. Afrer firmwered device not answer connect telnet, ssh, etc. Device answer only ping, nmap not show open ports.

Post #6
vincentfox
29 May 2009, 17:34

If you SEARCH the forum you will find a thread discussing 600n that indicated it was what is called "Work in Progress".   So I wouldn't expect it to work.

http://forum.openwrt.org/viewtopic.php?id=17586

The discussion might have continued from here.