OpenWrt Forum Archive

Topic: Enabling SNMP on pre-built image

The content of this topic has been archived on 1 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Post #1
Zappo5
5 Jun 2009, 22:52

Apologies in advance.  I'm a newbie to this.

I belong to a small community based WISP in Santa Fe, NM.  We are currently evaluating Ubiquity Nanostation2 boxes as replacements for our current APs.  We tried using them with the native firmware (AirOS 3.4), but we've noticed that it is spewing certain packets which are hosing our gateway router.  For that reason I'm evaluating several other firmware loads.  I was able to flash the latest Kamikaze on to the box and get it configured, but what is missing is any way to monitor the box using SNMP.

How does one get SNMP working in Kamikaze?

Thanks in advance for you help...

Post #2
aport
5 Jun 2009, 23:08

You could use opkg to install it:

opkg install mini-snmpd

You would have to configure it by hand; I don't believe there is an SNMP application in LuCI.

(Last edited by aport on 5 Jun 2009, 23:09)

The discussion might have continued from here.