Hi all there.
As you can read above I got a WRT54Gl v1.1 which is bricked now.
The moment I got it into my hands, was the moment I was flashing OpenWRT onto it and (that's what I guess at least) sort of messed up the config.
Could it be, that I disabled LAN in the configs?
Nethertheless when I started the router, the PowerLED was flashing, DMZ was dead and after a while DMZ went on(PowerLED still flashing) and after that, the final state was, that PowerLED went on and DMZ complettly shut off.
In that state was worked no telnet, no ping, no ssh.

Now I read this thread
http://forum.openwrt.org/viewtopic.php?id=20538
speaking about failsafe-mode, which I entered (PowerLED and DMZ are flashing, that's it right?)
but still nothing works.

I got my IP set to 192.168.1.102
Subnetmask: 255.255.255.0
gateway: 192.168.1.1

Thankful for any help
Greetz SPL

EDIT
New State: In failsafe-mode, I can enter the router via telnet
Next Step: Get networking back or refresh with firmware...we'll see

(Last edited by spiderpigloki on 10 Jun 2009, 12:30)