The content of this topic has been archived on 5 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Hi guys,
I have installed the gw6c (with ssl support from http://wiki.andy.id.au/Home/openwrt/gw6c-ssl),
because the offical one has no ssl.
It works well, however, I cannot reboot the router if I have started the gw6c, even not firstly start then stop it manually.
At the other hand, if I disable it, not let it start, I can reboot normally. because I have no way to see the syslog after I type reboot, so cannot figure out why
My router is brcm2.4 based, Openwrt is 8.09.1.
Thanks.
Which router are you using?
I haven't had this issue with my WRT54GL that uses this package. Can you check if you have enough space on your JFFS filesystem to install all the packages?
You could try my complete firmware which is at http://wiki.andy.id.au/Home/openwrt/custom-builds (you will need a router with at least 4MB flash).
The discussion might have continued from here.