Topic: compex wpe53g

The content of this topic has been archived on 20 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Page 1 of 1

Post #1

simblumb

24 Aug 2009, 10:58

I'm looking for a guide to undertake the following

I have some compex wpe53g and wish to load openwrt and use.
Searched for the serial pin outs and the firmware to be used, could not find any.
Any help would be appreciated.

Thanks!

Post #2

thirdwheel

26 Aug 2009, 05:33

Hi,

Well I did a quick googling and found that it does indeed support OpenWrt. Follow the firmware upgrade instructions to install OpenWrt.

It seems to have an Atheros SoC processor. Grab the kamikaze images for "atheros" and you should be all right.

Post #3

simblumb

28 Aug 2009, 11:52

Thank you.

Two specific queries :
1. Refer the download link for atheros below:
http://downloads.openwrt.org/kamikaze/8.09.1/atheros/

Quite a few have the ubiquiti name on it. Which file do I choose?

2. Have not been able to get hold of the serial pin outs on the compex wpe53g.

Any help will be deeplay appreciated.

Thanks

The discussion might have continued from here.

Page 1 of 1