I'm a owner of a wag354g (v1) and there is almost no develpment here on this router but it works fine.
A guy named "blue" wrote how to compile a working image for this device and it seems to work! Thanks blue
I will quote his post:
I’ve got the 8.09.1 version of Kamikaze running nicely on my wag354g (v1).
Simple steps are: (For Linux)
1) download and untar the code.
2) run “make”
This isn’t going to create a working version, but it’s needed.
3) Once finished, edit “target/linux/generic-2.6/config-2.6.26? and change the two following lines:
4) Apply the cpmac.c patch as above. I added 1 extra line, according to “https://dev.openwrt.org/ticket/3923?
5) run “make”
6) The working image should be called “bin/openwrt-WA31-*” for wag354g v1
That’s it. I’ve found that you need udevtrigger or it doesn’t work.
As a guide if the power lights goes crazy it works, if it flashes green constantly you’ve not got udevtrigger, and if there is a single red flash every few seconds, the switch isn’t detected/configured.
If someone has something to add, post here. Let's make a better support to this old but great router/gateway
(Last edited by TigTex on 31 Aug 2009, 03:03)