I got problem with first booting kamikaze 8.09 on Routerboard 532A nand. I tried precompiled package:
http://downloads.openwrt.org/kamikaze/8 … 32-vmlinux
and also sources from SVN.
I have checked ramdisk in menuconfig and put vmlinux to tftp then boot...
Console message:
(...)
failed to execute /etc/preinit. Attempting defaults...
kernel panic - not syncing: no init found. Try passing= option to ker.
Topic: rb532 flashing nand kernel panic
The content of this topic has been archived on 4 May 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
I have made it works at last, but i must use an older package downloaded from:
http://wifi.ozo.com/airo/openwrt/firmwa … 32-vmlinux
But there is no Luci GUI attached... Have anyone an idea, why newest Openwrt doesnt works or how to install GUI at old openwet version (7.0.9)?
(Last edited by davidns on 18 Jan 2010, 21:11)
The XWrt gui is working now on my RB532 from
http://downloads.x-wrt.org/xwrt/kamikaz … rootfs.tgz
But i got another serious problem - if I enable eth1 or eth2 interface and connect cable to the port, then got kernel panic and system restart or halt:
kernel panic - not syncing: Fatal exception in interrupt
anyone got this problem?
The discussion might have continued from here.
Page 1 of 1